Hans Grohe Metris 31103XX1 Manual do Utilizador

Metris31102XX1Metris31103XX1Installation Instructions / Warranty

10Limited Lifetime Consumer WarrantyThis product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”).

11give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in court against us under the Magnuson-Mos

Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004Tel. 770 360-9880 • Fax 770 360 9887www.hansgrohe-USA.comUS - Installation Instr

2Metris Electronic Lavatory Faucet with Temperature Control31102XX1Metris Electronic Lavatory Faucet31103XX1Technical DataMax. water pressure 116 psi

3InstallationFlush the hot and cold supplies thoroughly before install-ing this faucet.Place the faucet in the hole on the mounting surface (1).Tighte

4Turn the water on to the faucet (1).Peel the protective film from the sensor (2).Wait 15 seconds, the place a hand in front of the sensor (3). The w

5Cleaning:Block the sensor for 5 seconds (1). This will turn the water off for approximately 90 seconds, so that the sink may be cleaned (2).Faucet M

6Wait 15 seconds (3). Place a hand in front of the sensor (4). The water should turn on.Clean the filters and aeratorIf the flow of water is reduced

7To clean the filters: Turn the water off at the stops.Disconnect the supply hoses from the adapters. Remove and clean the filters. Note: Remove and

8Replacement Parts1 aerator 986120002 solenoid valve 988540003 fixation set 978120004 connection hose 988090005 check valve 964560006 elect

9Cleaning Recommendation for Hansgrohe ProductsModern lavatory faucets, kitchen faucets, and showers consist of very different materials to comply wit